Seaward PrimeTest 50 Instructions d'exploitation télécharger pdf (Page 20)

PrimeTest 250

Operating Instructions

Power ON/OFF = press and hold CLI and CLII

simultaneously

Class I appliance test = press the CLI key

Class II appliance test = press the CLII key

Cord / extension lead test = press the CLI key

Enter Setup Mode = press the SETUP key

Once in the setup mode the CLII button can be

used to the change the Insulation voltage while

the LKGE button can be used to change the ILEAK

pass/fail limit. To leave the setup mode press the

SETUP button.

30mA RCD test = press the 30mA RCD key

3 phase appliance test = press the 3 phase key

Note: The PrimeTest 250

will automatically

switch OFF after approximately 1 minute if no

keys are pressed.

Note: When a key is pressed to initiate a test

sequence, the PrimeTest 250

will compare

the type of appliance connected with the test

sequence that has been selected, and where

possible, will prompt the user if an inappropriate

test has been selected.

For example, if an IEC lead is connected between

the front panel mains socket and the IEC socket

on the end panel and a CLI appliance test is

selected, the PrimeTest 250

will ﬂ ash the Cord

test enunciator to indicate that the Cord test is

the most appropriate test.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Pas de commentaire

Seaward PrimeTest 50 Instructions d'exploitation Page 20